Continue making further measurements, or right-click or press Esc to exit measurement mode. Click OK to close the dialog and return to the workspace.This lists the straight line distance between the chosen start and end points for the measurement, as well as the component X and Y distances. Click or press Enter to define the end point. As you do so, the Status Bar will reflect the straight line distance, as well as dx and dy values. Move the cursor to the required measurement end point.Position the cursor then click or press Enter to define this point. You are prompted (via the Status Bar) to select the start point for the measurement.Choosing the Reports » Measure Distance command from the main menus.Īfter launching the command, the cursor changes to a cross-hair and you will enter measurement mode.This command can be accessed from the Schematic Editor by: Measurements are made in accordance with current units of measurement - mils or mm - as defined through the Properties panel (when no object is currently selected).This command is used to measure the distance between two points on a schematic document.Change the Snap Grid (shortcut G) if you cannot accurately position the cursor at the required points.This command is used to measure the distance between two points on a schematic document.
0 kommentar(er)
